INTEGRA SATEL
33
Notes:
• The control panel analyzes telephone signals in order to recognize whether the call is
answered. Therefore, it may occur that you will hear the message after few seconds (up to
4 seconds) from picking the handset. This is not an error – the effect is a result of the
phone call-back signal. When you say "hallo..." to the handset, the message will be
reproduced immediately.
• Acknowledgement of message reception by the user can reset the function of messaging
to other users PROG.
6.14 A
NSWERING PHONE CALLS
The INTEGRA control panel is able to answer phone calls and transmit information on the
system status. It makes also possible to call control functions with the use of telephone. Each
ordinary user (at the stage of user entering or editing) may have a telephone code assigned
(which is not to be mixed with the code acknowledging receipt of a telephone message on
alarm). The control panel recognizes the system user with this code makes available
information on status of the partitions (armed, alarms) which the user has access to. The
given user may also control the status of control panel relay outputs programmed as the
R
EMOTE SWITCH
. The installer is capable of programming up to 32 such remote switches in
the INTEGRA 128. The installer also decides which relays may be controlled by individual
users. To use this function of the control panel, you must have a DTMF-compatible telephone
set.
Note: Not all cellular telephones allow control in DTMF tone system.
How to use this function:
• Dial the telephone number (line) of the control panel. The method of dialing is defined by
the installer. The control panel may establish connection after a defined number of dialing
signals (rings). The dialing can be single or double. When double dialing is used, wait until
a defined number of “rings" is completed, put the handset off, and then dial the control
panel telephone number again. After the number is dialed the second time, the control
panel should answer immediately.
• After the connection is established, the control panel is ready to receive the user telephone
code – three short beeps (handshake).
• Enter the code from the telephone keypad (in tone system). The control panel will
acknowledge the correct code with a series consisting of four short and one long beeps.
Two long beeps follow receipt of an incorrect code.
• The control panel is in partition status information mode. It waits for user’s response for 15
seconds, generating one short beep every two seconds. You are expected to enter the
partition number from the telephone keypad (in two-digit format, e.g., 01; 05; 12; 25). If
there is no response within this time, the control panel will ring off.
• After the partition number is entered, the control panel generates the message. Three
short beeps inform that the partition is disarmed and four short and one long beeps mean
that the partition is armed.
• Alarm memory is the extra information given by the control panel. If an alarm occurred in
the partition, the control panel generates a series of double beeps – one lower and the
other higher – following the partition status information. If there was no alarm, the control
panel will generate a single short beep every two seconds.
• In order to proceed to the control of the remote switches status, press [2] and [#] on the
telephone keypad. After the control function is entered, a periodic signal in the form of two
short beeps can be heard in the receiver.
To Next Page
Loading...
