Satel INTEGRA - Change Prefix; Masters; Users

INTEGRA SATEL
43
In the first two cases, the procedure of entering a new code is simple: having started the
function, enter the new code and confirm it by pressing the [#] key.
If the code has been guessed, the procedure is more complicated, as it requires confirmation
of the code change by the master user or the serviceman: having entered the new code,
confirmed by pressing [#], it is necessary to enter the master code or the service code (in
case the master user code has been guessed).
Note: Using the service code is possible after enabling the service access by the master
user.
It is possible for the service to activate the option which blocks creating easy-to-guess codes.
When this option is activated, the control panel does not allow to create such codes as e.g.
1111, 1234, 1122 etc. These codes will be rejected, and the control panel will wait for another
combination of digits.
Note: The control panel does not recognize the code which is identical to the old code as a
new one.
Change prefix
This function, which is available to the master user only, makes it possible to change the
system prefixes. (see page 28).
The installer, using the corresponding service function (ÆService mode ÆOptions ÆPrefix
length), can determine the prefix length (1–8 digits). If the length of prefixes programmed by
the installer is 0, the function forcing the prefixes to be inserted before the user function will
be disabled.
If prefixes (
NORMAL
and duress) are used in the security alarm system, the master user of
each object must change the default setting of the prefixes and define the time period to the
next change (1–255 days).
Masters
This function is used for entering new users with master authority level, changing data related
to the existing master user, or for removing the master user. Only the installer having a
service code is authorized to use this function. Only one user with such authority level may
be assigned to each object. The list of all rights which may be assigned to the master user is
identical to that shown in the description of the U
SERS
function. The function makes it
possible to select the keypads, locks and card readers which could be operated by the given
master user. The introduced changes become valid in the system as from exiting the function
by pressing the [
*
] key and accepting the changes with the key [1].
Note: In order to create a new administrator, an access code must be assigned to him.
Users
This function makes it possible to enter new users in the system, as well as edit or remove
the existing ones.
Note: A user will be created after at least one identifier is assigned to him: an access code,
proximity card, DALLAS chip or key fob.
For each user, the following can be defined:
Code – a password assigned to the new user (if the new user is authorized to change his
own code, he should change it!).
Telephone code – a code by which the system will recognize the user in the answering
phone calls function. If this code is not assigned, the user will be unable to check the