SATO CL6NX - Page 127

6 Installation of Options
125
CL4NX/CL6NX Service Manual
16 Attach the front cover 1 to the printer.
17 Attach the dispenser unit  and tighten
four screws
.
Note
Before attaching the dispenser unit, make sure that
the NIP springs are in the correct position.
If the NIP spring is in the wrong position, push the
NIP spring in the arrow direction using a long nose
pliers.
5
34
33
Correct position
The end of the spring is positioned on the bearing.
Wrong position
The end of the spring is positioned on the groove.