SATO CL6NX - Page 128

6 Installation of Options
126
CL4NX/CL6NX Service Manual
18 Open the dispenser unit, attach the
dispenser bar
 and tighten the
screw
 .
Align the center line on the dispenser bar  to
the mark on the engine frame, and then
tighten the screw
 .
19 Then attach the front cover  of the
dispenser and tighten two screws
$.
Attach the back of the front cover to the
protruded tab as shown.
20 Tighten a screw  from the rear side of
the dispenser unit.
21 Close the dispenser unit.
22 Attach the left housing cover 2 and
tighten the screw
4.
3
37
36
35
38
Center line
7
6
Slide