6 Installation of Options
127
CL4NX/CL6NX Service Manual
Checking and Adjustment after the Installation
Test print checking
1 After you load the media and ribbon,
close the print head and top cover.
Then power on the printer.
If you have installed the liner rewinder, confirm
that the time (hh:mm) is showed on the right top
corner of the LCD screen.
2 Perform a test print (refer to Tools > Test
Print > Factory in Chapter 4 Operation
and Configuration of the CL4NX/CL6NX
operator manual) to check the following
items:
• Check the dispense operation to make sure that
there is no slack on the liner.
• Check to make sure that the dispenser sensor
can sense the label.
Before the label is removed from the dispenser
bar, the “waiting for media removal” status icon
is shown. When the label is removed, the
printer continues to print the next test print and
then stops for label removal.
• Check that the media stop position is correct.
The regular position is to let the label stay
about 2.0 mm (0.08") on the liner. If not, adjust
the offset value.
Refer to the Printing > Advanced >
Adjustments > Offset menu in the chapter 5
of CL4NX/CL6NX operator manual to adjust
the media stop position if necessary.
• Check that the liner is rewound correctly (liner
rewinder model).
To Next Page
Loading...
