6 Installation of Options
135
CL4NX/CL6NX Service Manual
22
Attach the left housing cover 0 and
tighten the screw
".
Checking and Adjustment after the Installation
Preparation:
• Load direct thermal media to the printer for checking the print position. (Linerless media is not
required)
• Check that the firmware version is 1.3.0.r7 or later. (Refer to Information > Build Version in Chapter
4 Operation and Configuration of the CL4NX/CL6NX operator manual)
Error message checking
1 After you load the media and ribbon, close the print head and top cover. Then power
on the printer.
2 Pull the tab to open the cutter-open
lever.
11
10
Place down
& Slide
Cutter-open lever
Open
To Next Page
Loading...
