5 Replacement
82
CL4NX/CL6NX Service Manual
CL6NX
Required tool:
• Phillips screwdriver (JIS #2 or equivalent)
1 Make sure that the printer is in power off mode, then disconnect the power cord from
the AC outlet.
2 Remove the left housing cover.
Refer to Section 5.1.1 Remove the Left Housing Cover.
Refer to Section 5.8 Replacing the Interface Board to remove the interface board if applicable.
3 Remove the rewind core unit if it was
installed to the dispenser model.
Refer to Section 5.15 Replacing the Torque
Limiter for Liner Rewinder (Optional) to
remove the rewind core unit.
4 Disconnect all the cables from the
connectors on the main (CONT) PCB.
Refer to the step 3 of Section 5.5 Replacing the
Main (CONT) PCB for details.
5 Remove four screws . and then
remove the main (CONT) PCB
assembly (with bracket)
3.
6 Remove three screws $ attaching the
media holder plate
/.
To Next Page
Loading...
