173
(1) [Page Setup]
Sets the size and sensor type of the media set to the printer.
(2) [Print Options]
Adjusts the settings of the print speed, print darkness, and base reference point.
(3) [Print Mode]
Sets the print mode of the printer.
(4) [Graphic Options]
Specifies dithering and the graphic form when sending to the printer.
It is not necessary to change it in particular, and it is available with initial values.
(5) [Custom Commands]
Specifies the method to control the printer behavior directly.
It is best to use this method only if user understands the SBPL command or the programming
references.
(6) [Maintenance]
Returns the printer driver settings to their initial values.
(7) [International]
Selects the unit to be used.
(8) [About]
Shows the version of the printer driver and provides access to the SATO homepage.
Outputting a Label from an Application Software
The method for starting a print job varies depending on application software. In general, print jobs
begin when you click [Print] button in the dialog that is displayed after selecting [Print] from the [File]
menu. Refer to the user manual of the application software you are using.
To Next Page
Loading...
