683
Cleaning the Print Head and Platen Roller
Cleaning Intervals
Clean the printer at the following regular intervals.
• The below cleaning intervals are only for reference. Clean the printer when necessary
even if you are not at a regular interval.
• After you print one media roll or print media for 150 meters (492.1 feet).
Use the cleaning kit to clean following parts:
◦ Print head
◦ Platen roller
◦ Media sensors
◦ Media guide
• After you print six media rolls or print media for 900 meters (2952.8 feet).
Use the cleaning sheet to clean the following parts:
◦ Print head
◦ Platen roller
Use the cleaning kit to clean following parts:
◦ Media route
◦ Ribbon route
Cleaning interval for the optional linerless cutter kit (CL4NX only) is as follows:
• After you print one media roll or whenever there is any glue residue or paper dust on the media
route.
Use the cleaning kit to clean following parts:
◦ Print head
◦ Media guide
◦ Media sensors
◦ Guide rollers
• There is no need of cleaning the linerless platen roller unless it is significantly soiled.
Cleaning Using the Cleaning Kit
The cleaning procedure using the cleaning kit is as follows:
To Next Page
Loading...
