[Network]
280
• You can connect a maximum of 10 devices.
• When Wi-Fi Direct is active, [Device Name] cannot be changed.
• [Start Group] and [Remove Group] are shown only if Wi-Fi is active and the printer is
not connected to a Wi-Fi Direct network.
• [Remove Group] is shown if Wi-Fi is active and the printer is connected.
• After setting up a start group, the printer will be set to the GO (Group Owner) and will
wait for a connection request from another device.
• If the printer is powered off during a persistent group connection, the group will be
started automatically after the printer is powered on.
[SSID]
Set the SSID.
The screen shows the Wi-Fi network detected by the printer.
Select the name of the Wi-Fi network you want to connect using the / buttons and press the
button to confirm.
To register a Wi-Fi network manually, press the button and enter the name of the network.
You can enter a maximum of 32 characters. Alphabets (capital and small letters), numbers and
symbols can be used.
To Next Page
Loading...
