SATO CL6NX - Page 761

761
• You can set the external signal (EXT) type (TYPE1 to TYPE4) for Print Done output
signal of pin No. 6. Refer to the [EXT Mode] screen of the [Settings] > [Interface] >
[External I/O] > [Signals] menu for details.
• You can set the pin number for input and output through the [Settings] > [Interface] >
[External I/O] > [Signals] > [Inputs] and [Outputs] menu.
• The Print Done signal of pin No. 6 is not outputted when 0 is specified in the number of
cuts in the command specifying the number of cuts during the cutter operation.
Timing Chart of the EXT Input Signal
Item Input Waveform
Print Start
Reprint (No
Print Start
Signal)
Reprint
(With Print
Start Signal)