SATO PW208NX - Page 126

Starting Up the Printer
123
Mobile printer PW208NX/PW208mNX
Setting Items Initial Setting/Value User Reset Factory Reset
Advanced – – –
Calibrate Auto-Calibration – –
Auto-Calibration
PW208NX: Gap + I-Mark No No
PW208NX: I-Mark No No
Gap Sensor – – –
Emission Level 3 No No
Receiving Level 64 No No
Slice Level 0.0 V (Auto) No No
I-Mark Sensor – – –
Emission Level 3 No No
Receiving Level 64 No No
Slice Level 0.0 V (Auto) No No
Head Check All
○ ○
Head Chk Mode Always
○ ○
Every Page 1
○ ○
Chk Media size Disabled
○ ○
Adjustments – – –
Offset 0 dot No No
Pitch 0 dot No No
Darkness Adjust 50 No No
Start Online Enabled
○ ○
Feed After Error Disabled
○ ○
Feed At P-On Disabled
○ ○
Finisher Feed 0 dot
○ ○
Paper End Sensor (PW208NX only) Using I-mark:
○ ○
Prioritize Commands
○ ○
Reprint Disabled
○ ○
Print End Pos. (Print End Position) 0 dot
○ ○
Dispenser Mode PW208NX: Auto
PW208mNX: None
○ ○