SATO PW208NX - Dispenser Mode (PW208 NX Only); Switching to the Dispenser Mode

30
Mobile printer PW208NX/PW208mNX
Before You Start
1.7.1 Switching to the Dispenser Mode
1
Open the top cover.
Push the cover open button (

).
Open the top cover (

).
1.7 Dispenser Mode (PW208NX only)
3
Load the media.
Pull out the media for one sheet, and then load
the media so that the surface touches the print
head.
If the media is difcult to load, rewind the media
roll so that the two ends of the roll become even.
4
Close the top cover.
Make sure the media t between the dispenser
unit and top cover, and close the top cover so
that it clicks shut.
The print mode (

page 52) automatically
switches to Dispenser mode after setting up the
dispenser unit.
2
Set up the dispenser unit.
Slide the dispenser lever (

), and
set up the dispenser unit (

).
②
①
②
①
• When setting up the dispenser unit, be careful not to get cut your nger with the cutter.
Use only the supply products specied by SATO.
Before use, check the printer operations with the media to be used.