SATO PW208NX - Page 55

52
Mobile printer PW208NX/PW208mNX
Starting Up the Printer
Print Mode
Printing > Print Mode
Set the print mode.
Initial setting : Tear-Off
Setting options : Tear-Off, Linerless, Continuous
Tear-Off : After printing the specied number of sheets continuously,
the media roll is fed to the cutter position automatically.
In this mode, the media roll is easily cut manually after
printing. For the next printing, the media roll is fed back to
the print head and printing starts.
①
②
①
②
①
②
①
②
②
①
②
Media feed direction
Simple cutter
Before printing
Backfeed
Printing
End of printing
Tear-Off operation
Operations
Cutting
Print head
Media
sensor
Linerless : Cut each sheet of media after printing the specied
number of sheets continuously.
Continuous : The specied number of sheets are continuously printed.
After printing the specied number of sheets or printing a
single sheet, the next print start position is placed at the
print head.
①
②
①
②
①
②
Media feed direction
Simple cutter
Before
Printing
End of printing
Print head Media
sensor
Note
When the dispenser unit is set ready for dispenser print (

page 30), the
print mode automatically switches to the Dispenser mode. (PW208NX only)
Dispenser : The liner is peeled from the printed sheet of media.
Once the printed sheet has been removed, the next
sheet of media is set at the position for printing.