18
Mobile printer PW208NX/PW208mNX
Before You Start
About Batteries
• The battery pack (the lithium ion battery pack) has a life expectancy. Even if the battery is fully charged, operation
time gradually becomes shorter. It is the battery’s characteristics, not an error or problem. We recommend that you
replace the battery after approximately 300 charge cycles or 3 years from the date of rst use, whichever is earlier.
• The charging time (about 3 hours) is for reference. It depends on temperature around the battery or its conditions.
• If you notice any dents or cracks on the battery pack crust caused by strong impacts or shocks, stop using the
battery pack immediately and replace it with a new one. Continued use under these conditions may lead to abnormal
overheating or re.
• Charge the batteries in a place of 5 to 35°C (41 to 95 °F). Charging in high or low temperature may cause battery
deterioration.
• If the printer is too hot or too cold, keep the battery in a place of 5 to 35°C (41 to 95 °F) for about 1 hour then charge
the battery. Charging between 10 and 30°C (50 to 86°F) is recommended.
• When the battery temperature becomes higher or lower than the specied temperatures, the printer enters the
standby mode for charging and stops charging.
• If the battery has not been charged for a long period of time, it may become unusable. Charge the battery regularly.
• Do not keep the battery fully charged. The battery may become deteriorated.
• Do not keep the battery in high temperature. The battery may become deteriorated.
• For how to use the battery charger, refer to the manual of the battery charger.
1.2.4 Charging with Battery Charger (Optional)
Remove the battery from the printer and use the battery charger to charge it.
For details, refer to the operation manual supplied with the 1ch battery charger.
* The shape of power plug varies
depending on the region.
Outlet
AC power plug
Battery Charger
(Rear)
AC adapter
Battery
Set the battery with the
terminals facing
backward.
(Front)
Eco-charge
To Next Page
Loading...
