SATO PW208NX - Battery Menu

88
Mobile printer PW208NX/PW208mNX
Starting Up the Printer
2.6.3 Battery Menu
In the Battery menu, the setting items are as follows:
Battery
1 Health
Shows the battery condition.
The condition is displayed with Good, Replace
and Poor.
You cannot change the setting.
2 Cycle Counts
Shows the cycle count (charge/discharge cycle).
You cannot change the setting.
3 Eco Charge Set up the Eco Charge function.
4 Full Charge P-Off
Set up the printerʼs power-off function after
charging is complete.
Battery condition (Health)
Good : Battery is in a good condition for use.
Replace : Battery is in a condition that requires replacement.
Poor : Battery is deteriorated and in a condition that requires replacement.
Eco Charge
Battery > Eco Charge
Set up the Eco Charge function.
The Eco Charge function is designed to extend the battery life by keeping the after-
charged volume of the battery a little lower than the fully charged volume, thus
delaying the degree of deterioration.
Initial setting : Disabled
Setting options : Enabled, Disabled
Enabled : Enable the Eco Charge function.
Disabled : Disable the Eco Charge function.
Note
When using the printer being set on the charging cradle, Enabled is
recommended.