SATO PW208NX - Page 54

Starting Up the Printer
51
Mobile printer PW208NX/PW208mNX
Auto Measure
Printing > Auto Measure
The printer automatically measures the length of the media.
The measured length of the media will be automatically saved in Label Length.
The Auto Measure function is available when Sensor Type is set to Gap or
I-Mark.
Initial value: Disabled
Setting options:
Enabled, Disabled
The setting procedure of the level length using the Auto Measure function is as
follows:
1. Load the media.
2. Set Auto Measure to Enabled.
3.
Press the
button or
button to display the Online or Ofine screen.
4. Open the print head. (Head Open error occurs.)
5. Close the print head. (The display returns to Ofine screen.)
6.
Press the
button so that the printer feeds two sheets of label and
measures the label length.
7. The measured label length is saved in Label Length.
Note
When you have set Auto Measure to Enabled, this function is executed
when the printer is powered on.
Speed
Printing > Speed
Set the maximum print speed.
Initial value : 4 ips (inches/sec)
Setting range
: 3, 4 ips (inches/sec) (If Linerless)
: 3 to 6 ips (inches/sec) (If Tear-off, or Continuous)
3: 75 mm/sec (3 inches/sec)
4: 101 mm/sec (4 inches/sec)
5: 127 mm/sec (5 inches/sec)
6: 152 mm/sec (6 inches/sec)
Notes
• Fast print speed may affect the print quality.
• The actual print speed may vary depending on the battery capacity,
environment, or print layout.
• If the print mode is set to Dispenser mode (

page 30), the print speed
is limited to the maximum 4 ips (inches/sec). (PW208NX only)