SATO PW208NX - Page 56

Starting Up the Printer
53
Mobile printer PW208NX/PW208mNX
Sensor Type
Printing > Sensor Type
Set the type of media pitch sensor to be used.
Initial setting : I-Mark
Setting options : None, I-Mark, Gap (PW208NX only: In Tear-Off or Continuous
print mode)
I-Mark : Use the reective type sensor to detect the reference position
(I-mark) on the media.
Gap: Use the transmissive type sensor to detect the reference position
(gap) on the media.
None: Disable the media pitch sensor.
Peeling Setting (PW208NX only)
Printing > Peeling Setting
To make settings for peeling motion, following setting items are available.
1 Backfeed Set the backfeed motion in the Dispenser mode.
2 Sensor Type
Set the type of media pitch sensor to be used in the
Dispenser mode.
Backfeed (PW208NX only)
Printing > Peeling Setting > Backfeed
Set the backfeed motion in the Dispenser mode.
Initial setting : Before
Setting options : None, Before, After
None : The printer does not backfeed after printing and dispensing the media.
Before
: Before printing, the printer performs backfeed motion to align the
front part of media with the print head position.
After
: The printer performs backfeed motion to align the front part of
the next media with the print head position after printing and
dispensing the media.
Sensor Type (PW208NX only)
Printing > Peeling Setting > Sensor Type
Set the type of media pitch sensor to be used in the Dispenser mode.
Initial setting : I-Mark
Setting options : Gap, I-Mark
I-Mark : Use the reective type sensor to detect the reference position
(I-mark) on the media.
Gap : Use the transmissive type sensor to detect the reference position
(gap) on the media.