SATO PW208NX - Page 72

Starting Up the Printer
69
Mobile printer PW208NX/PW208mNX
Wi-Fi (Wireless LAN model)
Interface > Network > Settings > Wi-Fi
To set the wireless LAN, set the following setting items:.
1 IPv4 Congure the IPv4 for the wireless LAN.
2 IPv6 Congure the IPv6 for the wireless LAN.
This item is not displayed when Wi-Fi Direct is selected.
3 Proxy Congure the proxy for the wireless LAN.
4 WPS Set the wireless LAN connection with the WPS (Wi-Fi
Protected Setup) function.
This item is not displayed when Wi-Fi Direct is selected.
5 Wi-Fi Direct Set up the Wi-Fi Direct function.
This item can be enabled only if you have selected
Infrastructure in the Mode menu.
6
SSID Display or set the SSID.
7 Hidden SSID Display or set the Hidden SSID (stealth function), when you
have selected Infrastructure in the Mode menu.
8 Mode Set the communication mode of the wireless LAN.
9 Channel Set the communication channel.
This item can be enabled only if you have selected Ad Hoc in
the Mode menu.
10 Security Shows the security (encryption method) for the network.
You cannot change the setting.
11 WEP Conf. Set up the encryption.
This item can be enabled only if you have selected WEP in the
Security menu.
12 WPA Conf. Set the WPA authentication.
This item can be enabled only if you have selected
WPA+WPA2 or WPA2 in the Security menu.
13 EAP Conf. Set the EAP authentication.
This item can be enabled only if you have selected
Enterprise(802.1x) or CCKM in the WPA Conf. or you have
selected Dynamic WEP in the Security menu.
Note
When you complete setting in each setting screen, press the
button to display the Wi-Fi screen.
While “Save Setting?” is displayed, press
button to enable the
input value in each setting screen.
When you press
button or power off the printer before the Wi-
Fi screen is displayed, the input content is canceled.