Scanreco G6 - Page 23

– 23 –
Scanreco – Service Manual G6 Radio Remote Control System
Connector Name Description
K1000 LED 1-8 LED output (9 pole connector)
Pin 1 LED 1
Pin 8 LED 8
Pin 9 +5 V Common anode
K1001 LED 9-16
K801 AI 1 Analog input 1 for safety actuator. Works for paddle lever, joystick,
safety potentiometer, (4 pole connector)
Pin 1 +5 V
Pin 2 analog signal
Pin 3 analog signal
Pin 4 GND
K802 AI 2
K803 AI 3
K804 AI 4
K805 AI 5
K806 AI 6
K807 AI 7
K808 AI 8
K809 AI 9
K810 AI 10
K811 AI 11
K812 AI 12
K813 AI 13
K814 AI 14
K815 AI 15
K816 AI 16
K820
K821
SDI 1-4
SDI 5-8
Safe digital input (10 pole connector), 0–5 V
Pin 1 +5 V
Pin 2 SDI 1
Pin 3 SDI 1
Pin 4 SDI 2
Pin 5 SDI 2
Pin 6 SDI 3
Pin 7 SDI 3
Pin 8 SDI 4
Pin 9 SDI 4
Pin 10 GND
K900 Encoder Encoder X3 with corresponding digital input for push function (11 pole connector)
Pin 1 +5 V
Pin 2 DI 36 (also in K903)
Pin 3 Encoder 1 signal
Pin 4 Encoder 1 signal
Pin 5 DI 47
Pin 6 Encoder 2 signal
Pin 7 Encoder 2 signal
Pin 8 DI 48
Pin 9 Encoder 3 signal
Pin 10 Encoder 3 Signal
Pin 11 GND