Scanreco G6 - Part 4: Appendix 2 - Sisp Safety Manual; Introduction; Basic Skills and Knowledge; SISP TM Overview

Scanreco – Service Manual G6 Radio Remote Control System
PART 4: APPENDIX 2 – SISP™ SAFETY MANUAL
Glossary
Term Description
E/E/PE Electrical/Electronic/Programmable Electronic [IEC 61508-4:2010]
FMEDA Failure Modes Eects and Diagnostic Analysis
FSA Functional Safety Assessment
IEC International Electrotechnical Commission
SISP
TM
Scanreco Integrated Safety Platform
SRDO Safety Related Data Object [EN-50325-5:2010]
1. Introduction
This Safety Manual contains detailed information, which is required to integrate the radio
remote control into a safety-related system. The safety manual is applicable for all Scanreco
remote control systems based on the SISP
TM
technology. The Safety Manual only specifies the
safety classified functions and interfaces of the radio remote control system.
2. Basic Skills and Knowledge
The person’s integrating the radio remote control system shall have experience of safety related
systems and understanding of the regulations and standards applicable to the product developed.
3. SISP
TM
Overview
SISP
TM
is an integrated safety platform in the Scanreco remote control system that handles all
safety classified aspects. SISP
TM
consists of one module in the transmitter and one module
in the receiver. The transmitter is carried by the operator and the receiver is mounted on a
machine and interfaces over CAN and digital HW signals. The transmitter and receiver
communicate via radio or cable.
Overview of Scanreco remote control safety platform.
– 1 –