– 56 –
Scanreco – Service Manual G6 Radio Remote Control System
8. Maintenance
CAUTION!
• Clean the Transmitter and /or Receiver exterior with a damp cloth.
• Never use high pressure water jets.
• Do not use sharp or pointed objects to clean with.
• Do not use solvents or flammable/corrosive materials for cleaning.
• Check the rubber bellows and rubber seals of the switches, buttons, levers, and joysticks for
damage. Immediately replace any broken rubber bellows and / or rubber seals.
• Only use original Scanreco spare parts.
• Make sure that no foreign objects are left in the product after maintenance.
• Always test and / or troubleshoot the product after maintenance to make sure the issue or
issues are resolved.
• Always carry out maintenance in a dry environment.
• Always carry out maintenance in an ESD-safe environment.
• Make sure that only maintenance technicians with a soldering certificate replace components
that require soldering.
!
WARNING!
During on-site maintenance work at the machine, always be cautious of unwanted and dangerous
machine movements.
!
NOTICE!
The inspection of the machine and Scanreco radio control system must comply with national
requirements, and it must be done by authorized companies, according to the statutory
inspection intervals.
i
8.1. System Level
8.1.1. Modulate
Modulate is a Windows software and digital servicing tool developed by Scanreco that allows you to:
• Connect to the transmitter or receiver via Bluetooth Low Energy (BLE).
• View and clear error codes.
• View, change and set parameters.
• Update firmware.
To Next Page
Loading...