Scanreco G6 - Page 68

– 68 –
Scanreco – Service Manual G6 Radio Remote Control System
STEP 3: Fit the gasket to the bottom section.
1. Fit the gasket to the bottom section.
2. Make sure that it is tightly fitted.
3. Make sure that no part is sticking out.
Gasket and bottom section
STEP 4: Mount the bottom section to the top section.
1. Mount the bottom section to the top section.
2. Make sure that no wires and no parts of the gasket are pinched.
STEP 5: Tighten the screws.
1. Use a screwdriver to tighten the screws (0.7 Nm torque).
2. Tighten the short screws
first and then the long screws .
3. Tighten all screws in a zigzag pattern, illustrated below.
Screws Mini Transmitter Micro Transmitter
Long screws (M4 x 40 mm) 4 4
Short Screws (M4 x 10 mm) 8 4
1
8
5
4
11
9
7
3
10
2
6
12