Operator’s Guide 101
Appendix A: Recalibration
Calibration automatically adjusts the scanner read
system to compensate for variations in scanner
components. Your scanner comes calibrated and
ready for use.
Reasons to Recalibrate
Recalibration should be performed for the following
reasons:
• Received “Recalibrate.... See Manual” message on
the scanner display panel
• Moved the scanner to a new location.
• Instructed to do so by Scantron Customer Support.
NOTE: Do not recalibrate unless required to do so.
Recalibrating too often can produce less than
optimal results.
A
In this chapter:
Preparing for Recalibration. . . . . . . . . A-102
Navigating the Background Menu . . A-103
Top Head Calibration . . . . . . . . . . . . . . A-104
Bottom Head Calibration. . . . . . . . . . . A-105
Exiting the Background Menu . . . . . . A-105
To Next Page
Loading...
