Chapter 3: Operating Your Scanner
Operator’s Guide 31
Scanning Sheets
Use the following procedure to scan a stack of sheets:
1. Verify that the scanner is ready to scan. The
display panel should display the following
message:
If there is nothing in the display, verify that you
have pressed a button (for about 2 seconds) to
bring the scanner out of sleep mode. If there is still
nothing in the display, verify that the unit is
plugged in and turned on. If necessary, see
Chapter 2, “Chapter 2: Setting Up Your Scanner”.
If the message is different from the one shown
above, refer to the Scanning Tests, Surveys, and
Ballots Using SelfScore guide (included with your
scanner) for instructions on display panel
messages.
2. Press the Press To Load button on the side of the
input tray and while holding it down, complete
steps 3 (optional), 4, and 5 in this procedure.
Depressing this lever allows the sheets you load to
To Next Page
Loading...
