BASCSOUL_EN
V02 | 10.2017
59
www.schaerer.com
Operation
5.11 Transport conditions
► Before moving the coffee machine, it is essential that you detach the drinking water supply, power supply and
waste water outlet.
► Before moving the coffee machine, check the floor for obstacles and uneven areas.
5.12 Switching off
5.12.1 End of operation
Standby mode
► Start machine cleaning [A] in the service menu, see figure below, if this has not already been done.
Cleaning is started.
► If necessary, clean daily and weekly.
► If there is an external drinking water tank, drain and clean it.
► Remove the waste water hose from the external waste water tank.
► Clean the waste water tank thoroughly with household cleaner and rinse with fresh wa-
ter.
► Insert the waste water hose back into the tank.
The machine is ready for beverage dispensing.
► Fit the grounds container back into the machine.
CAUTION
Improper transporting of the coffee machine can result in injuries.
Observe the general regulations for health and safety.
NOTE
Incorrectly transporting machines on a trolley may damage the machine.
Adhere to the following instructions when moving machines on a cart:
• For safety reasons, the cart must be pulled and not pushed when moving the coffee
machine.
• Only pull on the cart and never on the machine.
• The cart is not intended for transporting cargo.
The manufacturer cannot be held liable for any damage resulting from unintended use of the cart or from failure to
follow the operating instructions.
DANGER
The machine is still energised in Standby mode.
Do not remove machine casings.
Unplug the machine from the mains before doing repair work.
See "Cleaning" for detailed information.
After automatic cleaning, the machine can be shut down directly from the cleaning programme.
To Next Page
Loading...
