Schweitzer Engineering Laboratories SEL-321 - Page 154

3-44 Communications Date Code 20011026
SEL-321/321-1 Instruction Manual
Button
Pushed Results Displayed Comment
SELECT
SET P 1
AUTO = N
Shows Port 1 not presently designated AUTO.
Press SELECT to enter list mode and select new
setting.
SELECT
SET P 1
AUTO = N *
(*) at end of line indicates list mode entered. Press
(← or →) to step through list of AUTO selections.
→
SET P 1
AUTO = Y *
New AUTO setting is displayed. Press SELECT
to save this choice and move to next setting
category for Port 1.
SELECT
SET P 1
RTS_CTS = N
Shows RTS_CTS for Port 1 set to N. Press
SELECT to enter list mode and select new setting.
SELECT
SET P 1
RTS_CTS = N *
(*) at end of line indicates list mode entered. Press
(7 or 6) to step through list of RTS_CTS
selections.
→
SET P 1
RTS_CTS = Y *
New RTS_CTS setting is displayed. Press
SELECT to save this choice and move to next
setting category for Port 1.
SELECT
Save Settings
Yes/No?
Press SELECT again to save settings and exit the
SET P edit session. Press CANCEL to abort new
settings.