Seastar Solutions Optimus 360 Installation Manual

B-3
© 2014 SeaStar Solutions Optimus 360 Installation Supplement, Rev. B
Basic system configuration is set through the color CANtrak display
parameters. The display then broadcasts these settings to all the
system devices connected to the network.
Access the parameters by double-clicking on Main Color Display in
the Datalink workspace, then clicking on the Configuration tab.
Remember to click Write after making any changes.
B.2 System Setup
Figure B-2. Color display – System parameters.
System ParametersB.2.1
Display Station Set the instance of the display. The default is Main; you only need to
change the second station display instance.
System Type Set the appropriate system type from the drop-down list.
Number of Engines At the time of printing only twin engine configurations are supported,
except on Yamaha DEC systems, for which triple-engine configurations
are supported.
Number of [component] Enter the quantity of each listed component in your system.
RPM Source Set to Electronic Engines.
Tachometer PPR Not applicable

Seastar Solutions Optimus 360 Specifications

General

Brand	Seastar Solutions
Model	Optimus 360
Category	Automobile Electronics
Language	English