4-3
© 2014 SeaStar Solutions Optimus 360 Installation Supplement, Rev. B
7. Multiple helm stations only: choose Select Device Locations
from the System Setup menu and press >. The display will list
the installed components along with their serial numbers. Check
the serial numbers and use the + and – buttons to toggle the
components between Main and Second station. Press Save to
return to the System Setup menu.
4.2 Purge and Calibrate
4.3 Engine-Specific Setup
You are now ready purge and calibrate your steering system. Refer to
the Optimus EPS Installation Manual (Book 50) for instructions. Be
sure to perform the steering installation checks described in Book 50.
The steering portion of the system should now be fully functional.
Before you are ready to Sea Trial the steering system and set up the
joystick, you will need to perform some engine-specific setup activities.
You will find these in the section related to the engines you are using.
To Next Page
Loading...
Need help?
General