Seca 514 - Page 54

54 •
No access to seca patient
database of the seca 115 PC
software
No seca 360° wireless network set up
between device and the PC on which
the seca 115 PC software is installed
Administrator:
set up
seca 360° wireless network (see
“Setting up the seca 360° wireless
network” on page 40)
No Ethernet connection set up
between the device and the PC on
which the
seca 115 PC software is
installed
Administrator:
set up Ethernet connection (see “Integrate
device in an Ethernet network” on page 37)
Device connected to a standalone PC
via Ethernet cable. The PC’s network
card does not permit automatic
crossover
Administrator:
use a crossover adapter (see “Technical
information” on page 56)
No USB memory stick connected to
the touchscreen display.
Connect USB memory stick to the
touchscreen display
The PC on which the
seca 115 PC
software is installed is not switched on
Switch on the PC and start the seca 115
PC software
seca 115 PC software not started Start the seca 115 PC software
No seca CLS network set up
Administrator:
set up seca CLS network (see “Setting up
seca CLS network (via Ethernet only)” on
page 38)
seca CLS server of the
seca 115 PC
software not started
Administrator:
start seca CLS server manually
USB memory stick connected
to touchscreen display but no
access to the
seca patient
database
Non-initialized USB memory stick being
used
• Use the USB memory stick supplied
• Administrator: initialize USB memory stick
using the
seca 115 PC software
PIN not entered or entered incorrectly
Use your user PIN or the PIN for the USB
memory stick.
Unsuitable USB memory stick being
used
• Use the USB memory stick supplied
• Use a FAT16 USB memory stick
Interference from high-frequency emis-
sions from other devices (e.g. cell-
phones)
Increase distance from high-frequency
devices
Problem Cause Remedy