Configuring the device • 35
9. Press the apply button.
10. Switch the device off and back on again.
The settings are adopted.
Setting the date and time 1. Call up the Administrator menu.
2. In the drop-down menu, select the
Date/time element.
3. Press the field for the value you wish to set:
–
Date
–
Time
The numerical keypad appears.
4. Enter the current value.
5. Press the Enter key on the numerical keypad.
The set value appears in the corresponding field
6. Repeat steps 4. and 5. for every other value you wish to change.
7. If you have selected the time format
12 h under Region, ensure that the
am / pm setting matches actual time.
ATTENTION!
Loss of data, misinterpretation of measurements
The settings for date and time are not automatically synchronized with
the settings in the PC software. If the settings do not match, different
date and time details may lead to measurements being misinter-
preted.
► Ensure that the same settings for date and time are made both on
the device and in the PC software.
8. Press the
apply button.
9. Switch the device off and back on again.
The settings are adopted.
To Next Page
Loading...
