41
www.seuservice.com
When the game machines of a same or similar type are installed side by side, their sensors may
interfere with each other. To reject the interference, follow the procedure below.
The following game machines employ a same or similar type of sensor. If interference happens
to the sensors, operation of the games may be mutually disturbed.
THE HOUSE OF THE DEAD 2, U/R type, DX type and Super DX type
THE LOST WORLD, U/R type, DX type and Super DX type
BRAVE FIRE FIGHTERS
CONFIDENTIAL MISSION, U/R type and DX type
THE MAZE OF THE KINGS, U/R type and DX type
THE HOUSE OF THE DEAD 3, U/R type and DX type
VIRTUA COP 3, U/R type and DX type
PHOTO 6. 9
In order to prevent electric shock and short circuit hazards, be sure to turn
power off before performing work.
Be careful not to damage the wires. Damaged wires may cause electric shock
or short circuit or present a re risk.
Do not expose the IC BD, etc. without a good reason. Failure to observe this
can cause electric shock hazard or malfunctioning.
Work should be performed by the Location's Maintenance Man or technical
personnel. Performing work by those who do not have technical knowledge
and expertise can cause electric shock accident or malfunctioning.
THE INTERFERENCE PREVENTION WIRING
INTERFERENCE PREVENTION WIRING
SMB-60028
Disconnect the power.
Remove the 2 truss head screws that x the PTV
cabinet lid upper, and unlock. Thus remove the lid
upper.
An interference prevention wire is connected to the
board on the back of the Lid Lower.
If the game machines of a same or similar type are
installed side by side, place them alternately (place
the machine with an interference prevention wire
next to the machine without).
WARNING!
To Next Page
Loading...
