Sega VIRTUA COP - Static Convergence Adjustment

86
www.seuservice.com
87
www.seuservice.com
TEST MODE WRITING
POSITION
ADJUST
SELECT
RESET
R BG
PIC-ADJ
SET
P
ADJUST MODE
ADJUST MODE
ADJUST MODE
ADJUST MODE
ADJUST MODE
WRITING
(1) Keep pressing the TEST button for
approximately 3 seconds.
(2) Press the R button to have the red
adjustment mode.
(3) Make adjustment by using the
▲▼
ADJUST buttons.
(4) Press the B button to have the blue
adjustment mode.
(5) Press the WRITING button (for storing
and nish).
The screen will change to ADJUST
MODE from the Game mode to
cause the green test pattern to be
displayed on the screen.
The red test pattern is added to
the display. The frame color
turns red and this signies the red
adjustment mode.
Make adjustment so as to have red
superimposed on green. When
red is superimposed on green, the
color becomes yellow.
Similarly as in the case of red,
adjust the blue color. When green,
red, and blue are superimposed, the
color becomes white.
The WRITING display appears
and the adjustment data is stored.
After the data is stored, the Game
mode returns.
When either of the COLOR SELECT
buttons (R, B) is pressed, if the color
desired to be adjusted disappears,
press that particular button again. For
example, if the red color needs to be
adjusted again at the stage of Writing, the
R button need to be pressed twice.
In the STATIC CONVERGENCE adjustment, each of red and blue images is comprehensively
moved to and superimposed on the green color. If automatic color matching function is not
sufciently satisfactory, perform this adjustment. Be sure to perform automatic color matching
before starting the above adjustment.
DO NOT PUSH THIS.
STATIC CONVERGENCE ADJUSTMENT