80
www.seuservice.com
TEST MODE WRITING
POSITION
ADJUST
SELECT
RESET
R BG
PIC-ADJ
SET
P
REMOTE CONTROL LIGHT EMITTING PORTION
MODE (mode selection)
TEST (adjust/normal shift)
R. G. B. (color selection)
POSITION (to select the position)
ADJUST (adjustment)
WRITING (storing the data)
P (automatic color matching)
SET (to decide the selection)
PIC - ADJ (item selection)
RESET
SELECT (pattern selection)
When adjusting the Projector, direct the Remote Control's light emitting portion towards the
Projector Screen.
11-2 PROJECTOR ADJUSTMENT
In this product, set to INPUT LEVEL: 0.7 V and IMPEDANCE: 75Ω. Failure
to observe this can cause CRT membrane to burn or Shutdown device to function
resulting in power off.
The Projector's Connector Panel contains the Interface setting SW.
WINNER
LAMP
AC100-120V
~
AC100-120V
~
AC
IN
RGB
IN
COM
IMPEDANCE
INPUT LEVEL
HIGH
75
Ω
0.7V 1
~
3V
REMOTE CONTROL BUTTONS
SETTING THE INTERFACE
To Next Page
Loading...
