73
www.seuservice.com
In the cases where the gun's operation is not satisfactory or the gun sight deviates from the
direction in which the control unit is pointed, the gun's interior parts may have been damaged.
Replace the parts by disassembling the gun in the following procedure: Also, be sure to perform
sighting check in the test mode when the gun parts are replaced.
Do not cut the tie belt securing the wires in the Control Unit (Gun Controller).
Cutting the tie belt may cause malfunctioning of the wire connection. If you
cut the tie belt when replacing the wire etc., be sure to secure the wires using
a new tie belt as before.
Follow these directions carefully to avoid damaging or losing small parts.
10. CONTROL UNIT (GUN CONTROLLER)
In order to prevent an electric shock and short circuit, be sure to turn power
off before performing work by touching the interior parts of the product.
Be careful not to damage the wires. Damaged wires may cause electric shock
or short circuit or present a re risk.
Be very careful when soldering. Handling a soldering iron carelessly may
result in a re or a burn.
When securing the plastic-made parts, do not excessively fasten screws and
nuts. Failure to observe this may damage the parts and cause injury due to
fragments resulting from damage.
When reassembling the Gun Controller, be sure to check the connecting
portion and the trigger, etc. If the reassembling work is not sufcient and/or
correct, it may cause injury resulting from catching ngers.
CAUTION!
STOP
IMPORTANT!
WARNING!
To Next Page
Loading...
