91
www.seuservice.com
FLUORESCENT LAMP 18in
Coolwhite 15W
BILLBOARD PLATE
BILLBOARD SASH
TRUSS SCREW (3), black
M4×8
Slide up.
When performing work, be sure to turn power off. Working with power on can
cause electric shock and short circuit hazards.
The Fluorescent Lamp, when it gets hot, can cause burn. Be very careful when
replacing the Fluorescent Lamp.
Be sure to use lamps of the designated rating. Using lamps of undesignated
rating can cause a re or malfunctioning.
Be careful not to damage the wires. Damaged wires may cause electric shock
or short circuit or present a re risk.
To perform work safely and securely, be sure to prepare a step which is in a
secure and stable condition. Performing work without using the step can cause
violent falling down accidents.
Be careful when handling the plastic made parts. Failure to observe this may
cause injury due to damage or fragments resulting from damage.
INSIDE THE BILLBOARD
FIG. 13 a
Remove the billboard sash, slide up the billboard plate, and replace the uorescent lamp.
When performing work,
prepare a step.
13.
REPLACING THE FLUORESCENT LAMP/OTHER LAMPS
CAUTION!
WARNING!
To Next Page
Loading...
Need help?
General
