100
www.seuservice.com
Turn off power.
Take off the 2 screws from the cabinet, unlock, and remove the LID UPPER.
16-1 REMOVING THE GAME BOARD
PHOTO 16. 1 a
16. GAME BOARD
In order to prevent electric shock and short circuit hazards, be sure to turn power
off before performing work.
Be careful not to damage the wires. Damaged wires may cause electric shock
or short circuit or present a re risk.
Do not expose the Game BD, etc. without a good reason. Failure to observe this
can cause electric shock hazard or malfunctioning.
Do not use this product with connectors other than those that were connected
and used with the Game Board at the time of shipping. Do not carelessly con-
nect wires to connectors that were not used at the time of shipping, as this may
cause overheating, smoke or re damage.
In this product, setting changes are made during the test mode. The Game BD
need not be operated. Use the Game BD, etc. as is with the same setting made
at the time of shipment so as not to cause electric shock and malfunctioning.
Static electricity from your body may damage some electronics devices on the
IC board. Before handling the IC board, touch a grounded metallic surface so
that the static electricity can be discharged.
TRUSS SCREW (2), black
M4×16
Unlock.
LID UPPER
To Next Page
Loading...
