Sega VIRTUA COP - Replacing the Microswitch

74
www.seuservice.com
75
www.seuservice.com
To replace the Gun Controller's internal components, rst separate the left shell (Cover L) and
right shell (Cover R). The controller's internal components are mounted on the right shell, so
work with the gun lying on its right side. To replace the weapon change button microswitch,
rst remove the weapon change button from the right shell.
 Turn power off.
 Remove the 10 screws to separate the two shells.
PHOTO 10 a
 With the right shell lying at, carefully lift the left shell from the right shell.
PHOTO 10 b
COVER L
COVER R
REPLACING THE MICROSWITCH
SCREW (10), black
M3×10, w/small at & spring washers