Sega VIRTUA COP - Line Convergence Adjustment

88
www.seuservice.com
89
www.seuservice.com
TEST MODE WRITING
POSITION
ADJUST
SELECT
RESET
R BG
PIC-ADJ
SET
P
ADJUST MODE
ADJUST MODE
ADJUST MODE
ADJUST MODE
ADJUST MODE
ADJUST MODE
ADJUST MODE
WRITING
(Note 1) When the MODE button
is repeatedly pressed, the
adjustment modes will circulate
as follows:
STATIC ADJUSTMENT MODE
LINE ADJUSTMENT MODE
POINT ADJUSTMENT MODE
(Note 2) When either of the COLOR
SELECT buttons (R, B) is
pressed, if the desired color to
be adjusted disappears, press
that particular button again.
In the LINE CONVERGENCE adjustment, the adjustment point of the column line (vertical) or
row line (horizontal) is comprehensively moved for color matching. It is convenient to utilize
this adjustment when the color of the column line or row line is uniformly deviated.
The screen changes to ADJUST MODE
from the Game Board mode and displays
the green test pattern.
(1) Keep pressing the TEST button for approximately
3 seconds.
(2) Press the MODE button once to have the POINT
ADJUSTMENT mode.
(Note 1)
The crosshatch test pattern appears and
the vertically long MARKER is shown.
The selected color is displayed by
superimposing on green. The MARKER
will be in the color selected.
(4) By using the

POSITION buttons,
move the MARKER to the position to be adjusted.
Use the buttons to select the
column line, and the MARKER moves
in the right/left direction. However, the
movable range is predetermined.
Use the ▲ ▼ buttons to select the row
line and the MARKER moves in the up/
down direction. However, the movable
range is predetermined.
(5) Make adjustment by using the

ADJUST buttons.
The selected column line or row line
(shown left is the column line) can be
moved in the desired up/down or right/left
directions as applicable.
(6) Press the WRITING button (for storing and nish).
WRITING is displayed and the
adjustment data is stored. After the data is
stored, the Game Board screen returns.
(3) Using either R or B button, select the desired color
to be adjusted.
(Note 2)
Although the green color can
also be selected by using the G button, to avoid
the screen size change adjustment, do not choose
green.
DO NOT PUSH.
MARKER
LINE CONVERGENCE ADJUSTMENT

