Sel SEL-351S - Page 9

vii
Date Code 20080103 Instruction Manual SEL-351S Relay
List of Tables
Table G.3 SELOGIC Control Equation Operators (Listed in Processing Order) .................................... G.5
Table G.4 Relay Word Bits in Factory Setting Example ....................................................................... G.7
Table G.5 SEL
OGIC Control Equation Settings Limitations................................................................ G.12
Table G.6 Processing Order of Relay Elements and Logic (Top to Bottom)....................................... G.13
Table G.7 Asynchronous Processing Order of Relay Elements........................................................... G.15
Table H.1 Port Settings for Standard Mode DNP Operation ................................................................. H.2
Table H.2 Port Settings for Extended Mode DNP Operation ................................................................ H.2
Table H.3 Data Access Methods............................................................................................................ H.6
Table H.4 SEL-351S DNP3 Device Profile ........................................................................................... H.7
Table H.5 SEL-351S DNP Object Table................................................................................................ H.9
Table H.6 SEL-351S DNP Data Map .................................................................................................. H.14
Table H.7 Analog 105 Upper Byte Definitions.................................................................................... H.17
Table H.8 Analog 105 Lower Byte Definitions ................................................................................... H.17
Table H.9 Control Field ....................................................................................................................... H.17
Table I.1 M
IRRORED BITS.......................................................................................................................I.1
Table I.2 Error Types Reported by the Communications Report ...........................................................I.4
Table I.3 SPEED Setting and M
IRRORED BITS Messages......................................................................I.7
Table I.4 Example Three-Terminal M
IRRORED BITS ID Setup ..............................................................I.8
Table J.1 Function Code 01 Message Format.........................................................................................J.4
Table J.2 02 Function Code Message Format.........................................................................................J.5
Table J.3 Function Code 18 Message Format.........................................................................................J.5
Table J.4 Message Format for Lost SER Records ..................................................................................J.6
Table J.5 Acknowledge Message Format ...............................................................................................J.7
Table J.6 Supported Response Codes .....................................................................................................J.7
Table L.1 SEL Fast Message Protocol Format .......................................................................................L.5
Table L.2 Unsolicited Fast Message Enable Packet ...............................................................................L.6
Table L.3 Unsolicited Fast Message Disable Packet..............................................................................L.6
Table L.4 Permissible Message Periods Requested by Enable Message ...............................................L.7
Table L.5 SEL-351S Global Settings for Synchrophasors .....................................................................L.8
Table L.6 SEL-351S Serial Port Settings for Synchrophasors ...............................................................L.8
Table L.7 Time Synchronization Relay Word Bits...............................................................................L.11
Table L.8 SEL Fast Message Voltage and Current Selections Based on PHDATAV and PHDATAI...L.14