Selec VFD Series

FWD (RUN)
REV (DIR)
COM
S1
S2
K
3W (STOP)
K
S1
S2
Run
Stop
FWD
REV
0
1
S1
S2
Forward
Stop
K
Reverse
3: Three-Wire Control Mode 2
FWD (RUN)
REV (DIR)
COM
S1
S2
K
3W (STOP)
P5-18
Terminal Filtering
Time
2 ms- 100 ms
Default:
10 ms
44
User Manual
This parameter allows the user to customize the debounce time being used for the multifunction input
terminals. An increase in the filter time can protect the terminal from false activation in noisy
environments. However, that will also adversely affect the sensitivity of the terminals.
P5-19
Terminal Frequency
update Step Size
0.0- Upper Limiting Frequency (P0-09)
Default:
0.1 Hz
This parameter defines the step size that will be used in cases where the set frequency is being
updated using the multifunction input terminals.