Sena 10R - Powering On and Off; Charging the Device

10R
18
4.2 Powering On and Off
4.2.1 Headset
To power on the headset, press the Center Button and the (+) Button
at the same time while hearing ascending beeps and a voice prompt,
“Hello”. To power off the headset, press the Center Button and the (+)
Button at the same time while hearing descending beeps and a voice
prompt, “Goodbye”.
4.2.2 Handlebar Remote
To power on the device, tap the Front Button and the blue LED will
appear. To power off the device, press and hold the Front Button and
the Joystick for two seconds until red LED blinks.
4.3 Charging
You can charge the headset and the Handlebar Remote by connecting
the supplied USB power & data cable into a computer’s USB port or
USB wall charger. You can use any standard micro USB cable to
charge the units. You can also charge them on the road using the
cigarette charger. The charging LED turns red while charging and
turns blue when fully charged. It takes about 2.5 hours to be completely
charged.
or
$&$GDSWHU