Sena 10R - Checking the Battery Level; Volume Adjustment

10R
19
English
4.4 Checking the Battery Level
4.4.1 LED Indicator
When the headset or the Handlebar Remote is powering on, their red
,%$mASHESRAPIDLYINDICATINGTHEBATTERYLEVEL
mASHES(IGH^
mASHES-EDIUM^
mASHES,OW^
4.4.2 Voice Prompt Indicator
When you power on the headset, keep pressing the Center Button and
the (+) Button simultaneously for about 3 seconds until you hear three,
high toned beeps. Then you will hear a voice prompt indicating the
battery level. However, if you release the buttons as soon as the
headset turns on, you will not hear a voice prompt for the battery level
indication.
4.5 Volume Adjustment
You can easily adjust the volume by moving the Joystick up or down.
You will hear a beep when the volume reaches the maximum or
minimum level. The volume is set and maintained independently at
different levels for each audio source even when you reboot the
headset. For example, once you set the volume for mobile phone
handsfree, it will not change even if you adjust the volume for your
Bluetooth MP3 music. However, if you adjust the volume during stand-
by mode, it will affect volume levels of every audio source.
Function Handlebar Remote Headset
Volume up Move the Joystick up Tap the (+) Button
Volume down Move the Joystick down Tap the (-) Button
Button Operation Table for Volume Adjustment