Sena 10R - Mobile Phone, GPS, and SR10 Functions; Mobile Phone Call Making and Answering

10R
26
6 MOBILE PHONE, GPS, SR10
6.1 Mobile Phone Call Making and Answering
1. When you have an incoming call, simply tap the Rear Button or
the Front Button to answer the call.
2. You can also answer the incoming call by loudly speaking any
word of your choice if
Voice Activated Phone Answering (VOX
Phone) is enabled, unless you are connected to intercom.
3. To end a call, tap the Rear Button or press the Front Button for
2 seconds until you hear a mid-tone single beep, or wait for the
called person to end the call.
4. To reject a call, press the Front Button for 2 seconds until you hear
a beep while the phone is ringing.
5. 4HEREARESEVERALWAYSTOMAKEAPHONECALL
– Enter numbers on your mobile phone’s keypad and make a call.
Then the call is automatically transferred to the headset.
– Tap the Rear Button in stand-by mode to activate the voice
dialer of your mobile phone. For this, the voice dialing function
must be available on the mobile phone. Refer to
your mobile
phone manual for further instruction.
Note:
1. If you have two phones connected to your headset and you have an
incoming call from the second phone during the call of the first phone,
then you may still receive the call from the second phone. In this case,
the call from the first phone is on waiting mode. If you end a call, then it
will automatically guide you to the first phone call.
2. If you have a mobile phone and a GPS connected to your headset, you
may not be able to listen to the GPS voice instruction during the phone
call.