Sena 10R - Delete All Bluetooth Pairing Information; Remote Control Pairing; Factory Reset Settings; Exit Voice Configuration Menu

10R
53
English
13.14 Delete All Bluetooth Pairing Information
Voice Prompt
“Delete all pairings”
Factory Default N/A
Execute Tap the Rear Button
To delete all Bluetooth pairing information of the 10R, move the
Joystick up or down until you hear a voice prompt, “Delete all
pairings”ANDTAPTHE2EAR"UTTONTOCONlRM
13.15 Remote Control Pairing
Voice Prompt
“Remote control pairing”
Factory Default N/A
Execute Tap the Rear Button
To enter into Remote Control Pairing mode, move the Joystick up or
down until you hear a voice prompt, “Remote control pairing”. Then
tap the Rear Button to enter into Remote Control Pairing mode. The
HEADSETWILLAUTOMATICALLYEXITFROMTHECONlGURATIONMENU
13.16 Factory Reset
Voice Prompt
“Factory reset”
Factory Default N/A
Execute Tap the Rear Button
To restore factory default settings on the 10R, move the Joystick up or
down until you hear a voice prompt, “Factory reset”, and tap the Rear
"UTTONTOCONlRM4HE2POWERSOFFWITHAVOICEPROMPT“Headset
reset, goodbye”.
13.17 ([LW9RLFH&RQÀJXUDWLRQ0HQX
Voice Prompt
ő'ZKVEQPſIWTCVKQPŒ
Factory Default N/A
Execute Tap the Rear Button
4O EXIT VOICE CONlGURATION MENU AND GET BACK TO STANDBY MODE
move the Joystick up or down until you hear a voice prompt, “Exit
EQPſIWTCVKQPŒANDTAPTHE2EAR"UTTONTOCONlRM