Sena 10R - Installing the Speakers

10R
11
English
3.2 Installing the Speakers
1. Peel off each cover of the hook and loop fasteners for speakers
to expose the adhesive surface. Then, attach the fasteners to the
ear pockets inside the helmet.
2. Attach the speakers to the hook and loop fasteners for speakers
inside the helmet.
3. Peel off the cover from the other side of the double sided adhesive
tapes and attach the main unit on the left side of your helmet.
4. -AKESURETHATTHEMAINUNITSTICKSONTHEHELMETlRMLY-AXIMUM
adhesion occurs after 24 hours.
CAUTION:
Sena recommends using the hook and loop fasteners for main unit. The
double sided adhesive tape is provided for convenience, but is not the
recommended mounting method. Sena is not responsible for its use.