Sequential Prophet VS - SECTION 2 - PERFORMANCE CONTROLS; PROGRAM SELECTION AND VOLUME

16
SECTION 2
PERFORMANCE CONTROLS
SELECTING PROGRAMS
Set up the Prophet VS as described in Section 1. The Prophet VS is ready to
play when power is switched on.
When power is switched on, internal sound program 00 is selected automat-
ically, as shown in both the liquid-crystal display (LCD) and the light-emitting
diode (LED) Program display. To select a dierent program, simply press two
PROGRAM SELECT digits (00-99).
To select a cartridge program, insert a cartridge and switch Cartridge on: then
enter the desired two digits. (If a cartridge is not in place, Cartridge will not go
on.)
Note: The Prophet VS is basically intended to be heard in stereo.
Note: If the VS is not used for more than ve minutes, the LCD back-lighting
shuts itself o. It will reappear when you let the VS know you are back.
MASTER VOLUME
While playing the keyboard, gradually raise Master Volume to maximum while
lowering the monitor system volume to a comfortable level.
For best signal-to-noise performance, set Master Volume as high as possible
without overloading the inputs of the monitor system. Master Volume is best
used for a temporary reduction of level.
BALANCE
The Prophet VS has two audio output channels: left and right. As Balance is
turned to either end of its travel, the volume of one output channel increases
2
HOME

BACK