34
SECTION 5
ARPEGGIATOR
ARPEGGIATOR BASICS
Here is a fully-programmable, multi-featured arpeggiator, which can be used
for lots of tricks. The VS arpeggiator diers from most arpeggiators in that it
allows you to overdub a second arpeggiation. This feature, combined with an
easy method for inserting rests between notes, allows complex note patterns
to be created which resemble single-step sequences, yet are of a more spon-
taneous nature and tend to be less static.
These arpeggiated patterns are referred to as "sequences" in this manual due
to the VS1 ability to hold latched notes in memory when power is switched o.
Most parameters are adjusted through the Arpeggiator Option Select control,
and saved along with sound parameters as part of each program.
Since all programs have arpeggiator settings, rst try some of the factory pro-
grams before programming the arpeggiator.
1. Select the desired program.
2. Switch On-O/Rate on.
The main arpeggiator display appears:
ARPEGGIATOR
RATE: XX (depends on program)
3. Hold down some keys.
The VS plays the notes.
In some programs, you must continue to hold keys for the arpeggiator to run,
in other programs, the arpeggiator automatically latches the notes.
5
HOME
To Next Page
Loading...
