Sequential Prophet VS - Repeats; Split

39
Repeats
The arpeggiator can play each note up to four times before playing the next
note.
When the REPEATS option is selected, adjust the displayed value to the
desired number of times you want each note to play. For example, a value of 2
makes each note play twice.
There is lots of opportunity for interesting eects here. Try using Double
keyboard mode with various delay values with this as well.
Split
This option lets you arpeggiate one side of the keyboard while playing the
other, or arpeggiate both keyboard sides simultaneously. This option is only
eective with split programs. (Remember that programs can be linked to
themselves, so it is not necessary to split the keyboard with two dierent
programs.)
SPLIT can be changed any time without aecting notes already arpeggiated.
1. Select the desired split program.
2. Press Arpeggiator Option Select until the SPLIT display appears.
3. Adjust to the desired setting.
There are four arpeggiator SPLIT settings:
OFF
The arpeggiator ignores the split point, and arpeggiates the keyboard as a
whole.
RIGHT
Only keys to the right of the split point are arpeggiated. The left section of the
keyboard plays normally.
LEFT
Only keys to the left of the split point are arpeggiated. The right section of the
keyboard plays normally.
Note: If OCTAVES is set to 2 or 3, the arpeggiator may steal voices from the
right side of the keyboard, but not play them with the left (linked) program.
DUAL
When SPLIT is set to DUAL, keys below the split point are arpeggiated
separately from keys above the split point, producing two “layered” sequences
which play simultaneously.
Note: If you latch such a sequence, you will not be able to over dub later.
HOME

BACK