26
6. To store, switch Store on.
Its LED lights.
This prepares the Prophet VS to store the edited program.
The display will say "STORE PROGRAM TO" the current destination, internal
or cartridge.
7. If you decide you do not want to store the program, this is your chance to exit
the procedure by simply switching Store o.
8. Enter two digits for the storage destination. The program will be stored when
you enter the second digit.
If Cartridge is on and a ROM cartridge is mistakenly in place, it will ask you to
insert a RAM cartridge. After doing that, reenter the two digits.
When stored, the screen returns to the main message: PROGRAM #xx name
The new program now appears under the selected number.
9. If desired, protect the cartridge again by setting its Store switch to "Dis."
TRANSFERRING PROGRAMS AND WAVEFORMS
For back-up purposes, storing and re-loading programs on cartridge one at a
time is too time-consuming. Instead the VS allows you to store or load its en-
tire memory in one operation. Of course, after such operations, the VS or RAM
cartridge's previous contents are erased, so make sure you are not loading
over valuable programs or waveforms before using any of these operations.
Dump Internal to Cartridge
To store all one hundred programs, or all thirty-two RAM waveforms on car-
tridge at once:
1. Switch Store on.
2. Switch the cartridge Store switch to "Enable."
3. Switch Cartridge on.
4. Adjust the slider so the display reads:
COPY ALL PROGS or COPY ALL WAVES TO
CART (enter) TO CART (enter)
5. Press Enter.
6. The cartridge’s programs or waveforms are replaced by the VS’s current
memory.
HOME
To Next Page
Loading...
